This is my iPhone case I made on tinkercad.So we gotta square and then a circle hole and make a side.Then we made a phone case size and grabbed the sides and put them on the corners and made the sides into holes and grouped them together. Then I grabbed the same shape and then put it in the middle and shrank it and lifted it up a bit when I made it into a hole then grouped it.Then I got the cylinder and put them on the top and bottom and made them into a hole and then you did the same for the volume and on and off button.Them I grabbed the box and put it at the top and on the right and then made it into a hole and then groped again and do the same for the hole in the middle.The easiest part was when the man was doing it.The hardest part is when I could not make the corner.
I used tinkercad to make the phone case.